Name

fstrim — discard unused blocks on a mounted filesystem

Synopsis

fstrim [ −o offset ] [ −l length ] [ −m minimum−free−extent ] [−v] mountpoint

DESCRIPTION

fstrim is used on a mounted filesystem to discard (or "trim") blocks which are not in use by the filesystem. This is useful for solid-state drives (SSDs) and thinly-provisioned storage.

By default, fstrim will discard all unused blocks in the filesystem. Options may be used to modify this behavior based on range or size, as explained below.

The mountpoint argument is the pathname of the directory where the filesystem is mounted.

OPTIONS

The offset, length, and minimum-free-extent arguments may be followed by the multiplicative suffixes KiB=1024, MiB=1024*1024, and so on for GiB, TiB, PiB, EiB, ZiB and YiB (the "iB" is optional, e.g. "K" has the same meaning as "KiB") or the suffixes KB=1000, MB=1000*1000, and so on for GB, TB, PB, EB, ZB and YB.

−h, −−help

Print help and exit.

−o, −−offset offset

Byte offset in filesystem from which to begin searching for free blocks to discard. Default value is zero, starting at the beginning of the filesystem.

−l, −−length length

Number of bytes after starting point to search for free blocks to discard. If the specified value extends past the end of the filesystem, fstrim will stop at the filesystem size boundary. Default value extends to the end of the filesystem.

−m, −−minimum minimum-free-extent

Minimum contiguous free range to discard, in bytes. (This value is internally rounded up to a multiple of the filesystem block size). Free ranges smaller than this will be ignored. By increasing this value, the fstrim operation will complete more quickly for filesystems with badly fragmented freespace, although not all blocks will be discarded. Default value is zero, discard every free block.

−v, −−verbose

Verbose execution. When specified fstrim will output the number of bytes passed from the filesystem down the block stack to the device for potential discard. This number is a maximum discard amount from the storage device's perspective, because FITRIM ioctl called repeated will keep sending the same sectors for discard repeatedly.

fstrim will report the same potential discard bytes each time, but only sectors which had been written to between the discards would actually be discarded by the storage device. Further, the kernel block layer reserves the right to adjust the discard ranges to fit raid stripe geometry, non-trim capable devices in a LVM setup, etc. These reductions would not be reflected in fstrim_range.len (the −−length option).

AUTHOR

Lukas Czerner <lczerner@redhat.com>
Karel Zak <kzak@redhat.com>

SEE ALSO

mount(8)

AVAILABILITY

The fstrim command is part of the util-linux package and is available from ftp://ftp.kernel.org/pub/linux/utils/util-linux/.